1) welding anchor nail

Wiring, it must be based on wall line, wiring in both sides, in strict accordance with the design drawing to bolt location, the size of the accumulated error may occur in practical pay-off in the last row of bolt location.

Anchor pin must be vertical wall plate welding, bolt adjacent center distance deviation 2 mm or less, distance between any two deviation plus or minus 3 mm or less.

Must pay attention to the anchoring bolt thread protection.

Welding must be strong, and one by one hammering, bending welding quality inspection, clear welding slag.

2) back lining tile

Must be in strict accordance with the design requirements for the compression to the required thickness

Have to stagger the carpet seams between layers and stagger the amount not less than the drawings.

Card must be card tight, prevent the rebound quickly

3) module installation

Per block, line by line installation, ensure the nut is tightened in place

Column type tier, pay attention to the installation of compensation between row and row, when installation, in accordance with the drawings design requirements, compressed the required thickness.

To prevent loss, compensation must adopt u-shaped nail fixed on the on the ceramic fiber module has been installed.

Plastic pipe after transferred guard board, center, must carefully check module and casing in hole, especially around edges.

4) lining repair:

Ceramic fiber lining surface must be smooth, dense.

Casing in hole, it is necessary to adjust the folding layer or dense with ceramic fiber cotton, blankets.

Through the clearance between the module must be folded in half fiber blanket or fiber cotton stuffing way for renovation.

5) ceramic fiber module lining construction quality of ceramic fiber lining damage effects

Design in general, seven points, three points in the construction.Based on the application of ceramic fiber module lining construction quality investigation summary, we found that the cause of lining damage ceramic fiber module construction quality problems, mainly exists in several aspects:

Nut installation does not reach the designated position, cannot twist to the bolt, ceramic fiber module and furnace wall board failed to connect, high temperature, in use process module fall collapse.

Compensate the compaction degree is insufficient, high temperature compensation of compensation amount can not meet the requirement of the use of, appear module through the gaps between row and row, anchor bolt steel plate of high temperature oxidation and burning.

Ceramic fiber module lining repair does not reach the designated position, through the gap caused by high temperature flue gas penetration between modules, anchor bolt high temperature oxidation corrosion is serious, module fall off.